Using The Cli To Configure The Switch - Nokia ESB26 User Manual

2.
ETH3, ETH4 Two 1000Base T ports interface connectors
ETH5, ETH6 Two 10/100Base T/TX ports interface connectors
OPR Operation Indicator. A single two-color LED (Green/Red)
•
•
•
•
RST Local Reset and Hotswap button.
To perform Hotswap, press twice within two seconds before removing the card.
Power will be turned off for 20 seconds during which the card may be removed
safely.
SER1 RJ45 console connector used for initial configuration.
TX – Pin 2 (Going out of the switch)
RX – Pin 5 (Going into the switch)
GND – Pin 3
GND – Pin 4

Using the CLI to Configure the Switch

The configuration program uses a CLI (Command Line Interface) that enables you to start
using the switch quickly and without extensive background knowledge. It does this by
prompting you for the information required to perform basic configuration procedures.
Using the CLI, you will be able to do the following:
• Establish host names and interfaces
• Enable transparent Ethernet bridging
•
Configure Layer 2 switch protocols (GVRP, GMRP, Spanning Tree, etc.)
•
Configure VLANs
System parameters are stored in a non-volatile memory. They have to be set up only once
during initial setup.
Getting Started with the CLI
Configuration of the switch is done by connecting a VT-100 (or compatible terminal) to the
card RJ-45 (Console) connector.
The CLI operates automatically when you power on the switch. Before you start using the
CLI, you must do the following:
MN700004 Rev 01
Getting Started
Green: the unit is operational
Red: during power up and in faulty condition.
Blinking orange: when no image software is loaded.
Off: power is off.
7