Nokia ESB26 User Manual page 418

Sysloader Configuration Commands
The table below lists the Sysloader configuration commands.
Table APPENDIX-8 Sysloader Configuration Commands
C o m m a n d
config
mac-address
clean startup-configuration
clean java-image
clean boot-config
clean log-history
boot-mode
ip-address
config
The config command, in Sysloader mode, switches the CLI from Sysloader mode to
Sysloader Configuration mode.
The CLI prompt will change after executing this command.
Command Syntax
device name>config
mac-address
The mac-address command, in Sysloader Configuration mode, displays or changes the MAC
address of the switch. If no argument is specified, the current MAC address is displayed.
Command Syntax
device name(config)#mac-address [HH:HH:HH:HH:HH:HH]
Argument Description
HH:HH:HH:HH:HH:HH
Example 1
Displaying the switch's current MAC address:
device_name(config)#mac-address
Current base MAC Address of switch = 00:A0:12:1B:00:60
OutBand MAC Address (base + 1) = 00:A0:12:1B:00:61
Example 2
Assigning a new MAC address to the switch. The response indicates that the new MAC
address is accepted and stored in the switch's memory.
MN700004 Rev 01
APPENDIX
Loader, Sysloader and Dual Boot
D e s c r i p t i o n
Switches from Loader mode to Loader Configuration mode.
Displays or changes the switch's MAC address.
Sets the startup configuration file to the factory default values.
Erases the Java image from the switch's memory storage.
Clears the Sysloader EPROM.
Cleans all history records.
Sets the boot mode to primary, secondary or auto.
Sets the outband IP address of sysloader (used for manufacturing
only)
The switch MAC address.
XIII