Table of Contents
Advertisement
Nokia M11 User's Manual
5.1.7 SNMP page
The SNMP page is used to configure the SNMP-related parameters of
M11. In M11, the SNMP can be used only for writing/reading system
contact information and trap addresses. Trap address is an address to
which a trap is sent in case of an authentication violation.
Figure 5-13
Filling in SNMP settings
1. Enter contact information and system location information in the
corresponding fields.
2. Enable/disable authentication traps.
3. Add/delete user communities if needed.
Enter the name of the new user community into the field.
4. Enter trap destination addresses.
Enter the IP addresses of the hosts to which the traps are sent.
Enter also the community string related to this address.
5-20
SNMP page
E Copyright Nokia Networks Oy
C33833001SE_00
Advertisement
Table of Contents
