Nokia ESB26 User Manual page 26

2.
Table 2-4 Privileged Mode Command Summary
clear Clears a specified entry or entries from one of the tables (the command is available only
in Privileged mode).
configure Configuration from VTY interface (the command is available only in Privileged mode).
copy Transfers file to the target base (the command is available only in Privileged mode).
debug Enables the debugging options
disable Exits from Privileged mode (the command is available only in Privileged mode).
enable Enters Privileged mode (the command is available only in View mode).
reload Halts and performs a cold restart (the command is available only in Privileged mode).
self-test Shows built-in test results (the command is available only in Privileged mode).
session Telnet session commands (the command is available only in Privileged mode).
show Shows running system information.
telnet Start telnet client (the command is available only in Privileged mode).
terminal Terminal configuration setup.
ping Sends ICMP echo messages (the command is available only in Privileged mode).
traceroute Trace routing path (the command is available only in Privileged mode).
who Displays who is on VTY.
write Writes configuration to memory, network or terminal (the command is available only in
Privileged mode).
scp-image Secure copy.
swap Swaps the primaryand the secondary applications.
Accessing Privileged Mode
enable
The enable command, in View mode, allows accessing the Privileged mode. After entering
this command, the prompt symbol changes from an angle bracket to a pound symbol (#).
Command Syntax
device-name>enable
Example
device-name>enable
device-name#
MN700004 Rev 01
Getting Started
15