Configuring And Displaying Monitor Session - Nokia ESB26 User Manual

8.
Table 8-1 Default Traffic Monitoring Configuration
P a r a m e t e r D e f a u l t
V a l u e
Monitor Disabled
Session

Configuring and Displaying Monitor Session

Table 8-2 lists the monitor session commands.
Table 8-2 Monitor Session Commands
C o m m a n d
monitor session
show monitor
session
Setting Monitor Session
The monitor session command, in Global Configuration mode, starts a new traffic
monitoring session. Use the no form of this command to remove the monitor session or to
remove the source VLANs.
To add or delete VLANs to or from an existing traffic monitoring session you need to disable
the monitor session definitions and to create new monitor session.
Command Syntax
device-name(config)#monitor session {rx|tx} destination interface UU/SS/PP
device-name(config)#monitor session {rx|tx} source {vlan VLAN-LIST|interface PORT-LIST}
device-name(config)#no monitor session {rx|tx}
Argument Description
rx Sets the session to monitor ingress traffic.
tx Sets the session to monitor egress traffic.
interface The destination interface for a monitor session.
UU/SS/PP
vlan VLAN-LIST List of source VLAN IDs. Use commas as separators and hyphens to indicate
sub-ranges (e.g. 5-10,100). The VLAN IDs are in the range <1-4094>.
interface PORT- List of source interfaces. Use commas as separators and hyphens to indicate
LIST sub-ranges (e.g. 1/1/1-1/1/5, 1/1/20).
MN700004 Rev 01
Traffic Monitoring
D e s c r i p t i o n
Enables a port monitor session.
Displays the monitor session configuration.
70