Jumbo Frame Commands - Nokia ESB26 User Manual

22.
Example
device-name#show tls
TLS is enabled
TLS EtherType 0x7000
interface 1/2/1 TLS uplink

Jumbo Frame Commands

Table 22-4 Jumbo Frame Commands lists the jumbo frame configuring and displaying
commands.
Table 22-4 Jumbo Frame Commands
C o m m a n d
tls jumbo-frame
show tls jumbo-frame
Enabling Jumbo Frames
The tls jumbo-frame command, in Global Configuration mode, allows support of large
(10K) frames. The no form of the command restores the packet buffer size to its default
settings (1518 bytes).
The tls jumbo-frame command enables more efficient packet processing on workstations and
servers by increasing the maximum packet size to 10K.
Jumbo frames are frames larger than the standard Ethernet frame size, which is 1518 bytes
(including Layer 2 header and Frame Check Sequence (FCS)).
The default MTU size is also 10K bytes once jumbo frame support has been enabled.
NOTE 1. The tls jumbo-frame command will take effect only after reset. You need not save the
configuration for the jumbo frame to take effect.
2. The tls jumbo-frame command will not appear in the configuration file.
Command Syntax
device-name(config)#tls jumbo-frame
device-name(config)#no tls jumbo-frame
Displaying the Jumbo-Frame Configuration Status
The show tls jumbo-frame command, in Privileged (Enable) mode, displays the jumbo frame
configuration status.
Command Syntax
device-name#show tls jumbo-frame
MN700004 Rev 01
Transparent LAN Services (TLS)
D e s c r i p t i o n
Enables jumbo frame.
Displays the jumbo frame status.
270