20. Igmp Snooping; Introduction; Joining A Multicast Group; Leaving A Multicast Group - Nokia ESB26 User Manual

20. IGMP Snooping

Introduction

The BiNOS switch can use IGMP (Internet Group Management Protocol) snooping to
constrain the flooding of multicast traffic. This is done by dynamically configuring physical
interfaces to forward multicast traffic only to interfaces that are associated with IP multicast
devices. IGMP snooping requires the LAN switch to snoop on the IGMP transmissions
between the host and the router and to keep track of multicast groups and member ports.
When the switch receives an IGMP report from a host for a particular multicast group, the
switch adds the host port number to the forwarding table entry. When it receives an IGMP
Leave Group message from a host, it removes the host port from the table entry. It also
deletes entries periodically if it does not receive IGMP membership reports from the multicast
clients.
The multicast router sends out periodic general queries to all VLANs. All hosts interested in
this multicast traffic send join requests and are added to the forwarding table entry. The
switch forwards only one join request per IP multicast group to the multicast router. It creates
one entry per VLAN in the forwarding table for each MAC group from which it receives an
IGMP join request.
Multicast groups learned through IGMP snooping are dynamic. However, you can statically
configure MAC multicast groups by using the ip igmp snooping vlan static configuration
command. If you specify group membership for a multicast group address statically, your
setting supersedes any automatic manipulation by IGMP snooping. Multicast group
membership lists can consist of both user-defined and IGMP snooping-learned settings.

Joining a Multicast Group

When a host connected to the switch wants to join an IP multicast group, it sends an
unsolicited IGMP join message, specifying the IP multicast group to join. Alternatively, when
the switch receives a general query from the router, it forwards the query to all ports in the
VLAN. Hosts wanting to join the multicast group respond by sending a join message to the
switch. The switch CPU creates a multicast forwarding-table entry for the group if it is not
already present. The CPU also adds the interface where the join message was received to the
forwarding-table entry. The host associated with that interface receives multicast traffic for
that multicast group.

Leaving a Multicast Group

The router sends periodic multicast general queries and the switch forwards these queries
through all ports in the VLAN. Interested hosts respond to the queries. If at least one host in
the VLAN wishes to receive multicast traffic, the router continues forwarding the multicast
MN700004 Rev 01 243