Nokia ESB26 User Manual page 124

12.
spanning-tree priority
The spanning-tree priority command, in Protocol Configuration mode, assigns the specified
value to the STP bridge priority. The default value is 32768. The no form of this command
resets the default value.
Command Syntax
device-name(cfg protocol)#spanning-tree priority <0-65535>
device-name(cfg protocol)#no spanning-tree priority
Argument Description
0- 65535 The spanning tree bridge priority. The default value is 32768.
spanning-tree hello-time
The spanning-tree hello-time command, in Protocol Configuration mode, sets the time
interval in seconds between BPDU transmissions from the ports of this unit. You use this
command when the unit is the root of the Spanning Tree, or trying to become so. The default
value is 2 seconds and the range depends on the MaxAge value (between 1 and 10 seconds).
The no form of this command resets the default value.
NOTE
You cannot assign hello-time a value greater than MaxAge/2-1.
Command Syntax
device-name(cfg protocol)#spanning-tree hello-time <hello-time>
device-name(cfg protocol)#no spanning-tree hello-time
Argument Description
hello-time The time interval in seconds between BPDU transmissions from the ports of this unit.
The default value is 2 seconds.
spanning-tree forward-delay
The spanning-tree forward-delay command, in Protocol Configuration mode, sets the time,
in seconds, that the switch stays in each of the Listening and Learning states that precede the
Forwarding State. In addition, when a topology change is underway and has been detected,
this parameter is used to age all dynamic entries in the Forwarding database. The default
value is 15 seconds, and the range depends on the MaxAge value (between 4 and 30 seconds).
The no form of this command resets the default value.
NOTE
You cannot assign forward-delay a value less than MaxAge/2+1.
Command Syntax
device-name(cfg protocol)#spanning-tree forward-delay <forward-delay>
MN700004 Rev 01
Spanning Tree Protocol (STP)
113