Table of Contents
Advertisement
Chapter 8 Application
The following table describes the labels in this screen.
Table 128 IP Surveillance > Profile > Traffic Guarantee Profile: Add
LABEL
Name
Commit Rate
Peak Rate
8.6.12 IP Surveillance Device Configuration
You can assign traffic and power profiles to ports on each device. To access this screen, click IP
Surveillance > Configuration > Device Configuration. Select a device and click Edit Port to
access the following screen.
Note: If the selected device is an Access Switch, you can assign the Traffic Profile, Power
Profile and Power Management Profile. If the selected device is an Aggregate
Switch, you can assign the Traffic Guarantee Profile. You can also assign Traffic
Profiles to NVR Switches.
Figure 206 IP Surveillance > Configuration > Device Configuration: Edit Port - Access Switch
Figure 207 IP Surveillance > Configuration > Device Configuration: Edit Port - Aggregate Switch
The following table describes the labels in this screen.
Table 129 IP Surveillance > Configuration > Device Configuration: Edit Port
LABEL
Polling Interval
Active
252
DESCRIPTION
Specify the name of the profile. You may use 1-30 alphanumeric characters.
Specify the guaranteed bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port. The commit rate should be less than the peak rate. The sum of
commit rates cannot be greater than or equal to the uplink bandwidth.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port.
DESCRIPTION
Specify the polling interval for the device. Select from 1, 5, 10, 30 or 60 minutes.
Select ports and click this to activate them.
ENC User's Guide
Advertisement
Table of Contents
