Port Management; Basic Setting - ZyXEL Communications ENC User Manual

Chapter 8 Application

8.4 Port Management

8.4.1 Basic Setting

Use this screen to configure and manage basic port settings. To open this screen, select a device
that supports this feature in the OTV, Device View or Group View panel and click Application >
Port Management > Basic Setting.
Figure 165 Port Management > Basic Setting
The following table describes the labels in this screen.
Table 100 Port Management > Basic Setting
LABEL
Port Status
Power Management
This section is only available for devices that support Power-over-Ethernet (PoE).
Total Power(W)
Consuming
Power(W)
Remaining
Power(W)
Loop Guard
Active Loop
Guard
Basic Setting
216
DESCRIPTION
Click View Status to view the port's status and statistics for traffic flowing through the
port.
This is the total power in Watts the PWR model can provide over the Ethernet.
This field displays the amount of power the device is currently supplying to the connected
PoE-enabled devices.
This field displays the amount of power the device can still provide for PoE.
The device must have at least 16 W of remaining power in order to supply power to a PoE
device; even if the PoE device requested for a lower power supply than 16W.
Select this option to enable loop guard on the device.
The device generates syslog, internal log messages as well as SNMP traps when it shuts
down a port via the loop guard feature.
ENC User's Guide