ZyXEL Communications ENC User Manual page 133

The following table describes the labels in this screen.
Table 48 Event Action > Add/Edit
LABEL
General
Event Action Name
Notes
Email Notification
Enable
Mail To
Message Subject
Message Body
HTTP-POST Notification
Enable
Server URL
Post Data
Syslog Forward
Enable
Server URL
SNMP Trap
Enable
Trap Destination
Destination Port
Community
Run System Command
Enable
Command Name
Command
Attributes
Cancel
ENC User's Guide
DESCRIPTION
Enter a descriptive name for the new event action profile. This field displays the profile
name if you are modifying an existing profile.
Enter further information about the event action.
Select this to have the EMS send an e-mail to the specified e-mail address when it
receives the events. Clear this to disable it.
Enter one or multiple valid e-mail addresses of the person who should receive matched
events. Use a comma (,) to separate e-mail addresses.
This is the mail subject. You can include one or more variables by clicking them in the
list box. The available variables are Message of the alarm and Source of the alarm.
This is the mail content. You can include one or more variables by clicking them in the
list box. The available variables are Message of the alarm, Source of the alarm,
Category of the alarm, Severity of the alarm, Time when alarm was generated.
Select this to have the EMS send an HTTP POST request to a web server when it
receives the events. Clear this to disable it.
An HTTP POST request sends additional data to the web server. The additional data is
specified after the URL.
Enter the domain name or IP address of the web server to which the EMS will forward
the matched events.
Enter the additional data you wish to send to the web server.
Select this to have the ENC forward devices' system logs to the specified IP address
when it receives the events. Clear this to disable it.
Enter the IP address or domain name of a host to which the ENC will forward devices'
system logs.
Select this to have the ENC send an SNMP trap to the specified IP address when it
receives the event. Clear this to disable it.
Enter the IP address of a host to which the ENC will send the SNMP trap.
Enter the port number the specified host uses to receive the SNMP traps sent by the
ENC.
Enter the SNMP Get/Set community string which is the password the ENC uses to
communicate with the specified host.
Select this to have the ENC execute a file when it receives the matched events. Clear
this to disable it.
Specify the full path of the file on the ENC that you want to execute. For example,
C:\WINDOWS\system32\cmd.exe.
Specify the attributes of the specified file if any. Otherwise, leave this field blank.
Click this to discard the changes and close this screen.
Chapter 5 Event
133