Ip Surveillance Traffic Profile - ZyXEL Communications ENC User Manual

8.6.7.1 Add Link
Use this screen to monitor a connection between two devices in a Map. To open this screen, hold
the [Ctrl] key and select two devices in the Map shown, then click Add Link in the Map menu bar or
right-click the devices and click Add Link.
Figure 201 IP Surveillance > Map View > Add Link
The following table describes the labels in the Add Link screen.
Table 124 IP Surveillance > Map View > Add Link
LABEL
Device 1
Device 2
Port 1
Port 2
Cancel
Ok
After you configure the link settings completely, a line displays between two devices. The link
becomes gray when the ENC is trying to send poll messages to the device. It is green when the
connection between two devices is up or red when they are disconnected.

8.6.8 IP Surveillance Traffic Profile

You can configure traffic profiles with different allowable traffic ranges for High Definition (HD) and
Standard Definition (SD) camera types. HD and SD traffic profiles with normal traffic rates are
preconfigured. High Definition requires a greater traffic rate than Standard Definition. To access this
screen, click Application > IP Surveillance > Profile > Traffic Profile. To create a new Traffic
ENC User's Guide
DESCRIPTION
This field displays the first device's IP address that you selected.
This field displays the second device's IP address that you selected.
Select the port on the first device that the link is connected to.
Select the port on the second device that the link is connected to.
Click this to discard the changes and exit this screen.
Click this to save the changes and exit this screen.
Chapter 8 Application
249