ZyXEL Communications ENC User Manual page 220

Chapter 8 Application
Note: The table columns may vary depending on different device models.
Figure 168 Port Management > Bandwidth Control
The following table describes the labels in this screen.
Table 103 Port Management > Bandwidth Control
LABEL
Activate
Bandwidth
Control
Copy
Port
Commit Rate
Active
Ingress Commit
Rate
Peak Rate Active
Ingress Peak
Rate
Egress Rate
Active
Egress Rate
220
DESCRIPTION
Select this check box to enable bandwidth control on the device.
Click this to copy the selected port's settings to another port. The screen appears as
shown next.
Figure 169 Copy
Specify the port number to which you want to copy the selected port's settings. Click OK
to apply the changes to the Port Management > Bandwidth Control screen.
Otherwise, click Cancel to discard the change and close this screen.
This field displays the port number.
Select this check box to activate commit rate limits on this port.
Specify the guaranteed bandwidth in kilobits per second (Kbps) for the incoming traffic
flow on a port. The commit rate should be less than the peak rate. The sum of commit
rates cannot be greater than or equal to the uplink bandwidth.
Select this check box to activate peak rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port.
Select this check box to activate egress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going
traffic flow on a port.
ENC User's Guide