Configure The Printer Setup On The Network - Xante ScreenWriter 3 Manual

3. Change the printer's default TCP/IP address to the address
assigned by your System Supervisor, using the tab key to move
to the next octet.
4. Click Ok. Command Center's main menu reappears.
5. If necessary, enable the printer's Line Printer interface. The
Line Printer interface is enabled as the factory default.
a.
Fig. 5.22 Macintosh LPR Communications Control Window
b.
c.
6. Choose File: Quit. Command Center closes.
7. Restart the printer to make the new TCP/IP address take effect.

Configure the Printer Setup on the Network

There are several UNIX operating systems, including System V
(SYSV), Berkeley Standard Distribution (BSD), and Solaris. Each
system handles line printer modes differently. Your System
Supervisor must configure the print queue, communications, and
spool settings for your specific network environment.
_______________________________________
Choose Networking: TCP/IP: LPR Enable.
Click the option buttons to enable (ON) or disable (OFF)
the Line Printer interface on your printer.
Click Ok. The main menu reappears.
Ethernet Setup 5-27