Xante ScreenWriter 3 Manual page 76

6. Measure Line B. Use the following procedures to adjust the
printer for the correct line length.
a. Note the amount Line B is over or under 388.61 mms.
b. Press the Menu key until LINE B appears. Then, press
the Enter key.
c. Press the Menu key until the amount which would most
closely adjust the line to the desired length appears.
Then, press the Enter key. For example, if Line B is 389
mm instead of 388.61 mm as it should be, select -0.50
mm to shorten the line to 388.50.
7. Press the Reset key to return to the previous menu level. Then,
press the Menu key until XACT: TEST PAGE reappears and
press the Enter key to print a new test page.
8. Repeat steps 5 and 6 until the line measurements agree with
the lengths listed on the test page.
9. Press the On Line key when the line lengths are correct.
READY/IDLE appears in the window.
Now the printer's line lengths are calibrated correctly.
Command Center X-ACT
Use XANTÉ Command Center's X-ACT feature to calibrate printer
line lengths and correct inaccuracies in printing width, height, skew,
and angle.
Note: You must have XANTÉ Command Center and your printer's
current PPD installed before you can use Command Center's
X-ACT. You also need a 1/2 millimeter ruler and the printer
needs to be connected locally with Ethernet.
1. Open XANTÉ Command Center if necessary; then, select
General: More X-ACT. The More X-ACT Calibration window
appears (fig. 3.19).
3-40 Macintosh Setupbb ____________________________________