Xante ScreenWriter 3 Manual page 119

Spooling can be enabled for each interface independently through
XANTÉ Command Center or printer front panel Interface menus.
Command Center also allows you to manage jobs in the spooler print
queue.
Using the Front Panel
The Spooler can be enabled using the Spooler menu for the interface.
See "Interface Control" in chapter 6 for details.
1. Select the Interface (SETUP:I/F) menu.
2. Select the printer interface (SERIAL, PARALLEL, ETALK,
LPR, NETBEUI, or NVL PSRV) that you use to send files.
3. Select the Spool menu; then, select YES.
4. Press the On Line key to return the printer to the
READY/IDLE state.
Using XANTÉ Command Center
This option allows you to enable and control spooling on the
printer's hard drive.
To Enable the Spooler
1. Open XANTÉ Command Center and select Controller:
Spooler. The Spooler window appears.
Fig. 4.21 Configure Menu in the Spooler Window
___________________________________________ PC Setup 4-33