Ps_Files Folder - Xante ScreenWriter 3 Manual

The XANTÉ Utilities Installer loads the QuarkXPress PDF. To load
these PDFs manually
1. Load and configure the Adobe PostScript printer driver and
your printer's PPD following instructions in "Adobe PostScript
Printer Drivers" earlier in this chapter.
2. Copy the XANTE_3S.PDF for the series 3 printers from the
PDFs folder to the Xpress\PDF directory on your PC by typing
the following command, substituting the drive letter containing
the XANTÉ Utilities CD-ROM for [Drive].
COPY [Drive]:\PDFS\XANTE_3S.PDF C:\XPRESS\PDF
See the QuarkXPress section in the appendix for additional
information.

PS_Files Folder

This folder contains Adobe PostScript files to help setup and maintain
your printer and a PDF file, Overview.pdf, which describes these files.
These files can be downloaded to your printer using Send PostScript
File in XANTÉ Command Center (see "XANTÉ Command Center"
later in this chapter) or by typing the following DOS command,
substituting a different port, if necessary:
Clean.ps prints cleaning instructions for the Accel-a-Writer 8100,
8200, and PlateMaker II.
D.ps contains a Control-D (PostScript's end-of-job marker) for use
with applications that do not send a PostScript end-of-file.
Fonts.ps3 prints a list of Adobe PostScript 3 fonts resident on
XANTÉ PostScript 3 printers.
Fontsamp.ps3 prints samples of Adobe PostScript 3 fonts resident
on XANTÉ PostScript 3 printers.
___________________________________________
COPY FILENAME.PS LPT1
PC Setup 4-25