Xante ScreenWriter 3 Manual page 136

2. Click Update/Print to print an alignment test page. Click OK
in the Alignment message box.
3. Turn the test page so that -x is to the left and -y is at the top of
the crossed lines (fig. 4.33).
4. Check the current settings printed near the crossed lines. The
factory default is x = 0, y = 0, which should cause each line to
print 1" (25.4 mm) from the edge of the page.
Coordinates listed indicate the change from the factory default
in dots per inch. When you make a change using the slide bar,
coordinates at the bottom of the screen display the change in
the same units.
Note: If current settings are not the factory defaults and you
5. Measure the distance from the edge of the page to the -x line.
This distance is dependent on the y coordinate.
• To move the -x line away from the edge of the page, move
the slide on the vertical slide bar up (toward the -y).
4-50 PC Setupbb
Fig. 4.33 Align Printer Margins
must adjust the coordinates, it may be easier to reset to
the factory default before beginning. To do this, click
Reset Margins. Then print another alignment test page
(steps 1 and 2) using the factory defaults.
__________________________________________