Removing The Paper Cassette Feeder; Controller Board Upgrades - Xante ScreenWriter 3 Manual

Removing the Paper Cassette Feeder

1. Make sure the printer displays a READY/IDLE message.
Then, turn off the printer and disconnect the power cord from
the power supply (fig. 2.6).
2. Remove media from the multipurpose feeder and the output
tray. Close the multipurpose feeder.
3. Remove all paper cassettes from the printer. Pull each cassette
out until it stops. Lift up slightly and remove it from the printer
(figs. 2.16 and 2.17).
4. Remove the screws that secure the feeder to the printer (fig. 10.3).
Warning!
5. Lift the printer off of the feeder vertically until the printer is
free of the feeder's stubs (fig. 10.2). Set the printer on a stable
surface that will support its weight.
6. Repack the feeder in its original box and store it in a location
that meets the guidelines in "Printer Location" in chapter 2.
7. Set the printer up again following the instructions in chapter 2.

Controller Board Upgrades

RAM, Ethernet, 1200 dpi resolution, 10/100BaseT, and internal IDE
hard disk upgrades are controller board modifications. This section
covers installing SODIMM (Small Outline Dual Insertion Memory
Module), firmware (flash ROM), and Ethernet upgrades.
___________________________________________
The printer weighs approximately 58.5 lbs (26.5 kg)
without the toner, cassettes, and media installed.
• Always have two people lift the printer.
• Only lift the printer using the recessed grip areas on
the right and left sides.
Options 10-7