Xante ScreenWriter 3 Manual page 248

Flash ROM SIMM Bank
Fig. 10.8 Flash SIMM and SODDIM Banks
1. Remove the controller board panel following the instructions
earlier in this section.
2. Unpack the SIMM or SODIMM.
3. Remove the existing SIMM(s) or SODIMM(s) if necessary
using the following procedure (fig. 10.8).
Note: Remove the DRAM SIMM closest to the front of the
a. Pull open the latches on each end of the SIMM or
SODIMM bank.
Note: As the SIMM is released by the latches, it tilts
b. Pull the SIMM out at a 45 angle or a SODIMM straight
up and out of the bank.
10-12 Optionsbb
printer first. To remove or install a SIMM in the
DRAM banks labeled 1, remove the Flash SIMM first.
out of the bank (fig. 10.9). A SODIMM does not
tilt (fig. 10.10).
__________________________________________
SODIMMS