Xante ScreenWriter 3 Manual page 108

Note:
c. Select the amount of RAM installed on your printer. For
Windows 95 and 98, use the VMOption and then go to
step 4. For Windows NT 4.X, use Installable
Options:InstalledMemory and then skip to step 8.
4. Click the Graphics tab and set the printer's default resolution
for the highest resolution available on your printer.
5. Click the Details tab and make the following changes for a local
printer. These options are not available for a networked printer.
a. Under Timeout, make sure the settings are
Not Selected: 300
Transmission Retry: 900
b. Click Spool Setting and select the following options;
then, click OK to close the Spool Settings Window.
Spool Data Format: RAW
Enable bidirectional support for this printer (selected)
6. Click the PostScript tab.
4-22 PC Setupbb
This does not enable the Spooler on your printer.
The Spooler must be enabled using either the front
panel Interface menus or XANTÉ Command
Center. See "Spooler" in chapter 6 and "Spooler"
later in this chapter for details.
__________________________________________