Xante ScreenWriter 3 Manual page 68

1. Open XANTÉ Command Center and choose Graphics:
Linearization. The Linearization window appears (fig. 3.15).
2. Change the Linearization window LPI setting in the Print box
(fig. 3.15) to achieve 256 levels of gray for the resolution at
which you are printing.
Note: For 600 dpi, select 85 lpi; for 1200 dpi, select 106 lpi.
3. Print a Calibration Page to measure the printer's current
performance as a basis for the calibration. To do this use the
following procedure:
3-32 Macintosh
Fig. 3.15 Linearization Window
Any lpi may be used; measure the lpi that is to be used
for final output.
Setupbb ____________________________________