Notch
Installing the Ethernet Board
The Ethernet upgrade for the ScreenWriter 3 allows you to run
EtherTalk, Novell Print Server, NetBEUI, and Line Printer protocols
on your printer. After installing the Ethernet upgrade, see chapter 6
for information about configuring and using the Ethernet options.
Required Tools:
1.
Remove the controller board panel following the instructions
earlier in this section.
2.
Unpack the Ethernet upgrade and verify that it contains the
following items:
• Ethernet board • Ethernet Interface Panel
___________________________________________
45˚
Fig. 10.11 Installing a SIMM
• A small magnetized Phillips screwdriver
• A 3/16" hex nut driver
Gently Rotate the Simm
Into a 90˚ Position, Until
the Two Latches Catch
Options 10-15