Set Idiom Recognition using the MISC:IDIOMREC configuration
menu. Yes, the factory default, enables this feature; No disables it.
Initial Job
Initial Job allows you to direct the printer to execute a Sys/Start file
from an optional hard disk each time the printer is turned on.
Set Initial Job from the MISC:INITIAL JOB configuration menu.
Yes, the factory default, directs the printer to look for a Sys/Start file
during printer initialization. No disables this feature.
Interface Control
Your printer features three standard simultaneously active interfaces.
The LocalTalk port, the serial (RS232) port, and the parallel port
allow you to send files from Macintosh and PC computers
concurrently. The optional Ethernet port supports EtherTalk, Novell
Print Server, NetBEUI, and TCP/IP (LPR). See chapter 5 about
configuring the Ethernet interface for your network environment.
Use the Interface (I/F) configuration menus to set printer interface options.
I/F:IP ADDRESS
ENTER
192.009.200.201*
*Default address
6-18
Configurationbb
SETUP:I/F
TEST
I/F:RS232
I/F:PARALLEL
ENTER
PARALLEL:ENABLE
RS232:ENABLE
PARALLEL:HNDSHK
RS232:MODE
PARALLEL:MODE
RS232:BAUD RATE
PARALLEL:SPOOL
RS232:PARITY
RS232:FLW CNTL
RS232:DATA BITS
RS232:STOP BITS
RS232:SPOOL
Fig. 6.10 Interface Menus
______________________________________
ENTER
MENU
I/F: XXXX*
ENTER
ENTER
XXXX* :ENABLE
XXXX* :MODE
XXXX* :SPOOL
* XXXX will be replaced
by the selected interface
(LTALK, ETALK, LPR,
or NETBEUI
I/F:NVL PSRV
ENTER
NVL PSRV:ENABLE
NVL PSRV:MODE
NVL PSRV:PRTOCOL
NVL PSRV:SPOOL
NVL PSRV:TIMEOUT