Connecting The Power Cord - Xante ScreenWriter 3 Manual

2. Connect the printer to the appropriate port for the cable used
on your network.
Before using your printer, set it up for your network environment
and configure the Ethernet interface. See chapter 5 for details.

Connecting the Power Cord

Make sure the printer's power switch is off (the O is pressed in).
1.
2. Connect the power cable's female connector to the back of the
printer and the male connector to a standard electrical outlet
(fig. 2.33).
Warning:
2-26 Installationbb
Fig. 2.31 Connect to the Coaxial Port
Fig. 2.32 Connect to the UTP Port
Plug the printer into a dedicated, properly grounded AC
outlet. Do not use an extension cord. Use a surge
protected outlet to help prevent power source fluctuations
from damaging your printer.
_________________________________________