Print Queue Setup; Default Printer Setup - Xante ScreenWriter 3 Manual

Make sure your PC is connected to the network properly. You will
need to restart your computer for the new network changes to take
effect.
Note: MS Networks can delay updating the network for a few
minutes.

Print Queue Setup

Once your PC is restarted with the new network changes, you can
establish a print queue to your XANTÉ printer.
1. Run the Adobe PostScript printer driver installation.
2. Select Network Printer.
3. Click Browse. Click "+" to the left of Entire Network. A
domain called XANTÉ Printer should appear if a XANTÉ
printer with NetBEUI interface is on the network.
4. Click "+" to the left of XANTÉ printers to see a list of printers.
5. Select the appropriate printer and click "+" next to the selected
printer. Highlight the print queue and click OK.
6. Continue through the remaining instructions and select the
correct PPD for your printer. A test page will verify that your
system is configured correctly.
Your XANTÉ printer is added to the list of available printers.

Default Printer Setup

To select the XANTÉ printer as the default printer
1. Click Start and select Settings and Printer.
2. Right click the printer and select "Set as default."
_______________________________________ Ethernet Setup 5-33