Xante ScreenWriter 3 Manual page 56

INITDSKX.PS files are used to initialize hard disks attached to or
installed in your printer.
• Numbered files initialize the SCSI disk with the same device
number (INITDSK1.PS initializes SCSI disk #1, INITDSK2.PS
initializes SCSI disk #2, etc.) on the printer.
• INITDSKA.PS and INITDSKB.PS initialize the internal IDE
drive of the same designation (the A or B disk) on the printer.
• INITDSKS.PS initializes all SCSI and IDE drives attached to the
printer.
You must initialize a hard disk before it can be used to store
downloaded fonts or to set up a spooling queue. Initializing a disk
erases all information stored on that disk.
NOVELL34.PS prints instructions for setting up a XANTÉ printer
on a Novell network.
PARMDUMP.PS prints a list of settings for the communication
devices currently configured for your printer.
SETZONE.PS allows you to set your printer's EtherTalk zone
name. Open the file in a text editor, such as SimpleText, and change
"name of zone" in the parentheses to the name of your EtherTalk
zone. Save the file, and download it to your printer. Restart your
printer to make the change effective.
SET_IP.PS allows you to set your printer's IP address. Open the file
in a text editor, such as SimpleText, and change the IP address in the
parentheses to your printer's IP address. Save and download the file
to your printer. Restart the printer to make the change effective.
STARTPG.OFF disables the printer's start-up page feature,
preventing the page from printing automatically each time the printer
is restarted (see "Start-up Page" in chapter 6).
STARTPG.ON enables the printer's start-up page feature, causing
the page to print automatically each time the printer is restarted (see
"Start-up Page" in chapter 6).
SYSPARM.PS prints a list of current system parameters.
3-20 Macintosh Setupbb ____________________________________