Testing Wireless Devices - Visonic PowerMaster-10 Installer's Manual

– Configuring an option from the "Diagnostics" menu
To Select an Option:
[1]
Enter the Installer Menu and select the
[2]
Select the sub-menu option you need, for example:
[3]
Select the diagnostic function you wish to perform, for example:

3.9.2 Testing Wireless Devices

The PowerMaster enable to test the wireless devices attached to the panel. You can test all devices, one device
at a time, display devices' status and review RF problems, in case of any.
07.DIAGNOSTICS
To select the option you wish, enter the
guidance above and in section 4.8.1), then refer to the table below which provides you with detailed
explanations for each option.
Option
TEST ALL DEVICES
TEST ONE DEVICE
CONTACT SENSORS
MOTION SENSORS
GLASSBREAK SENS.
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
07.DIAGNOSTICS
WL DEVICES
WL DEVICES
Instructions
Here you can test all devices automatically, one after the other.
While in
TEST ALL DEVICES
The devices are tested in the following order: wall-mounted devices, keyfobs and
handheld devices.
At the end of the test process, the panel will present the following:
. Press
SHOW ALL DEVICES
SHOW ALL DEVICES
Note: Refer to
Pressing any key during the testing process will open the following options:
1. Press to jump to the next device group. For example, from wall-mounted
devices to keyfobs.
2. Press to continue the testing process
3. Press to exit the test process.
While in the handheld devices test process, indicated by the corresponding display,
for example, "TEST KEYFOBS 01", press any key of the selected handheld device to
initiate the test.
Here you can select a specific device you wish to test (Contact Sensors, Motion
Sensors, Glassbreak Sensors, Smoke Sensors, CO Sensors, Gas Sensors, Flood
Sensors, Temperature Sensor, Keyfobs, Keypads, Sirens or Repeaters).
Press to enter the
the device families. Press
MOTION SENSORS
example:
The following screens will appear:
Where Zxx indicates the device zone number.
If there is no device, the following screen will appear:
Press to test the selected device. The following screen will appear:
option (see section 4.2).
WL DEVICES
TEST ONE DEVICE
OPTION you wish
menu, select the option you wish to perform (see
, press to initiate the test.
to view devices' status.
section for further information on device status.
TEST ONE DEVICE
sub menu and use
< device family >
to enter the
.
Zxx:<device name>
.
.
Means and
scroll select
to scroll through
sub menu For
< location >
NO EXISTING DEV.
.
73