Enabling The Back Light; Configuring The Disarm Option - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

enable beeps
or
5.
6.
10:PIEZO BEEPS

4.10.3 Enabling the Back Light

Here you determine whether the keypad back lighting will remain on at all times or will turn on when a key is
pressed and turn off within 10 seconds if no further keystrokes are sensed.
The two options are: always ON and OFF after 10 s (default).
To Enable the Back Light
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
22:BACK LIGHT
4.
OFF after 10s
or
5.
6.
22:BACK LIGHT

4.10.4 Configuring the Disarm Option

Here you determine when it is possible to disarm the system:
A. Any time.
B. In AWAY mode, during entry delay, by using the PowerMaster-10 keypad or wireless sensor (keyfob).
C. In AWAY mode, during entry delay, by using a wireless device (keyfob) only (this is set as a default in UK to
comply with DD243).
D. During entry delay, or by using the PowerMaster-10 keypad in AWAY mode.
Options: any time (default), on entry wireless, entry + away kp (default in UK), or on entry all.
To Configure the Disarm Option
1.
DEFINE PANEL
54
Select between "enable beeps", "off when home" and "disable
beeps".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "OFF after 10s", and "always ON".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
or button to program any other
" or press the
or button to program any other
" or press the
button to take you to "
<OK>
button to take you to "
<OK>
D-302756