Factory Default; Serial Number; Partitioning; General Guidance - "Partitioning" Menu - Visonic PowerMaster 360 Installer's Manual

4. PROGRAMMING

4.10 Factory Default

The FACTORY DEFLT menu enables you to reset the PowerMaster 360 parameters to the factory default parameters.
To obtain the relevant parameters defaults, contact the PowerMaster 360 dealer. Reset factory default parameters as
follows:
Step 1
Select "09:FACTORY DEFLT"
menu

09:FACTORY DEFLT
Notes:
1) For PowerMaster 360 with 2 installer codes, INSTALLER code and MASTER INSTALLER code, only the master
installer code enables to perform the factory default function.
2) If the Soak Test is active, performing factory default will restart the Soak Test.

4.11 Serial Number

The SERIAL NUMBER menu enables reading the system serial number and similar data for support purposes only. To
read the system serial number and other relevant data proceed as follows:
Step 1
Select "10:SERIAL
NUMBER" menu

10:SERIAL NUMBER

4.12 Partitioning

4.12.1 General Guidance – "Partitioning" Menu
This menu allows you to enable/disable partitions in the system (for further details, see APPENDIX E).

4.12.2 Enabling / Disabling Partitions

To enable or disable the partition feature, proceed as follows:
Step 1
Select "12:PARTITIONING" menu

12:PARTITIONING
44
Step 2
Select "<OK> to restore"
<OK> to restore

Step 2
[1] Click next repeatedly to view
relevant data.

0907030000.
JS702766 L18.154
PANEL ID: 100005
J-702770 L18.154
JS702767 L01.023
JS702768 L02.003
PL8.0.10 1111
Step 2
Select whether to "Enable" or "Disable"
Partitions

Disable

Enable
Step 3
Enter Installer Code

ENTER CODE:
Definition
Control panel serial number
Control panel software version
Control panel ID for
PowerManage connectivity
Control panel default version
Control panel boot version
Control panel Remote
Software Upgrade downloader

version

Displays the PowerLink
software version

D-305735 PowerMaster 360 Installer's Guide
Step 4
Resetting of factory default
parameters is underway
PLEASE WAIT...

Step 3
[2]

to Step 1
Step 3 Step 4
Partitions are
now enabled
  to Step 1
Enable
Step 5
 to Step 1