Table of Contents
Advertisement
or
button repeatedly until the display will read [07:QUICK ARM].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [07:QUICK ARM].
You can now press the
"
" or press the
DEFINE PANEL
4.8.5 Configuring Bypassing Zones
Here you permit either manual bypassing of individual zones (through the USER SETTINGS menu), or allow the system to
"force arm" (perform automatic bypassing) of open zones during the exit delay. If desired, press the arming key again if you
want to eliminate the protest tone that sounds during forced arming. If a zone is open and forced arming is not permitted,
"NOT READY" is displayed and the system does not arm (the "Sad Melody" will sound). If "no bypass" is selected, neither
manual bypassing nor force arming is allowed.
Options: manual bypass (default in USA), force arm and no bypass (default).
Note: To comply with EN requirements, "manual bypass" or "force arm" must be selected.
Note: The option "force arm" is not applicable in the UK.
To Configure Bypass
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
Press
and make the selection and then press
7.
I
OK
The PowerMax10-G2 display will revert to [08:BYPASS].
You can now press the
"
" or press the
DEFINE PANEL
4.8.6 Configuring Panic Alarm Activation
Here you determine whether the user will be allowed to initiate a panic alarm by simultaneous pressing of either the two
panic buttons (on the keypad / wireless commander) or away + home (on a keyfob transmitter). Audible panic activates the
siren and simultaneously transmits a message via telephone. Silent panic only transmits a message via telephone.
The options are: silent panic, audible panic (default) and disable panic.
To Configure Panic Alarm Activation
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
D-302756
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [08:BYPASS].
or
button to take you to "
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
".
button
.
I
OK
I
OK
".
button
07:QUICK ARM
I
OK
SELECT OPTION
I
OK
07:QUICK ARM
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
08:BYPASS
I
OK
SELECT OPTION
I
OK
08:BYPASS
READY 00:00
47
Advertisement
Table of Contents
