Shutting Down An Aggregate Interface; Restoring The Default Settings For An Aggregate Interface - HP A3100-8 v2 SI Configuration Manual

This minimum threshold setting affects the aggregation state of both aggregation member ports and the
aggregate interface in the following ways:
• When the number of member ports eligible for being selected is smaller than the minimum
threshold, all member ports change to the Unselected state and the link of the aggregate interface
goes down.
When the minimum threshold is reached, the eligible member ports change to the Selected state,
•
and the link of the aggregate interface goes up.
Follow these steps to set the minimum number of Selected ports for an aggregation group:
To do...
Enter system view
Enter Layer 2 aggregate interface
view
Set the minimum number of
Selected ports for the aggregation
group
CAUTION:
If you set this minimum threshold for a static aggregation group, you must make the same setting for its
•
peer aggregation group to guarantee correct aggregation.
Configuring the minimum number of Selected ports required to bring up an aggregation group might
•
cause all the member ports in the current aggregation group to become unselected.

Shutting down an aggregate interface

Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
• When an aggregate interface is shut down, all Selected ports in the aggregation group become
unselected and their link state becomes down.
When an aggregate interface is brought up, the aggregation state of ports in the aggregation
•
group is recalculated and their link state becomes up.
Follow these steps to shut down an aggregate interface:
To do...
Enter system view
Enter Layer 2 aggregate interface
view
Shut down the aggregate interface

Restoring the default settings for an aggregate interface

Follow these steps to restore the default settings for an aggregate interface:
Use the command...
system-view
interface bridge-aggregation
interface-number
link-aggregation selected-port
minimum number
Use the command...
system-view
interface bridge-aggregation
interface-number
shutdown
36
Remarks
—
—
Required
Not specified by default.
Remarks
—
—
Required
By default, aggregate interfaces
are up.