Delta Electronics PCI-DMC-A01 Programming Manual page 86

Chapter 3 Operating Principles | PCI-DMC-A01 / PCI-DMC-B01
2) Set Servo Node ID and enable motion status display
Input Node ID and check "Timer" checkbox to enable motion status display
NodeID item: API function's argument variable "NodeID".
Timer Checkbox: Check to display the motion status. Uncheck to disable display.
3) Enter the values of the arguments for motion control
StrVel item: Starting velocity. API function's argument variable "StrVel".
MaxVel item: Maximum velocity. API function's argument variable "MaxVel".
Acc. item: Time required to reach maximum velocity. API function's argument
variable "acc".
Dec item: Time required to go from maximum velocity to 0. API function's argument
variable "dec".
4) Select motion mode and set motion distance.
Abs. Checkbox: You must check this if you want motion displacement to use
absolute coordinates.
S-Curve checkbox: You must check this box if you wish to use the S-curve velocity
curve.
Dist. item: Motion distance. API function's argument variable "Distance".
3-64
Figure 3.92
Figure 3.93
Figure 3.94
Revised March, 2012