Cisco WS-C6506 Software Manual page 390

Configuring MLS
To enable IP MMLS on an MSFC interface, perform this task:
Task
Enable IP MMLS on an MSFC interface.
This example shows how to enable IP MMLS on an MSFC interface:
Router(config-if)# mls ip multicast
Router(config-if)#
Use the no keyword to disable IP MMLS on an MSFC interface.
Displaying IP MMLS Interface Information
The show ip pim interface count command displays the IP MMLS enable state on the MSFC IP PIM
interfaces and the number of packets that are received and sent on the interface.
The show ip interface command displays the IP MMLS enable state on an MSFC interface.
To display the IP MMLS information for an IP PIM MSFC interface, perform one of these tasks:
Task
Display IP MMLS interface information.
Display the IP MMLS interface enable state. Router# show ip interface
Displaying the IP Multicast Routing Table
The show ip mroute command displays the IP multicast routing table on the MSFC.
To display the IP multicast routing table, perform this task:
Task
Display the IP multicast routing table.
This example shows how to display the IP multicast routing table for 239.252.1.1:
Router# show ip mroute 239.252.1.1
IP Multicast Routing Table
Flags:D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned
Outgoing interface flags:H - Hardware switched
Timers:Uptime/Expires
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
14-34
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT
M - MSDP created entry, X - Proxy Join Timer Running
A - Advertised via MSDP
Command
Router(config-if)# [no] mls ip multicast
Command
Router# show ip pim interface [type number] count
Command
Router# show ip mroute [group[source]] |
[summary] | [count] | [active kbps]
Chapter 14 Configuring MLS
OL-8978-04