Configuring Ingress Queue Characteristics; Mapping Dscp Or Cos Values To An Ingress Queue And Setting Wtd Thresholds - Cisco Catalyst 2975 Software Configuration Manual

Chapter 33 Configuring QoS
In the above DSCP-to-DSCP-mutation map, the mutated values are shown in the body of the matrix. The
Note
d1 column specifies the most-significant digit of the original DSCP; the d2 row specifies the
least-significant digit of the original DSCP. The intersection of the d1 and d2 values provides the mutated
value. For example, a DSCP value of 12 corresponds to a mutated value of 10.

Configuring Ingress Queue Characteristics

Depending on the complexity of your network and your QoS solution, you might need to perform all of
the tasks in the next sections. You will need to make decisions about these characteristics:
•
•
•
•
•
These sections contain this configuration information:
•
•
•
•

Mapping DSCP or CoS Values to an Ingress Queue and Setting WTD Thresholds

You can prioritize traffic by placing packets with particular DSCPs or CoSs into certain queues and
adjusting the queue thresholds so that packets with lower priorities are dropped.
OL-19720-02
Which packets are assigned (by DSCP or CoS value) to each queue?
What drop percentage thresholds apply to each queue, and which CoS or DSCP values map to each
threshold?
How much of the available buffer space is allocated between the queues?
How much of the available bandwidth is allocated between the queues?
Is there traffic (such as voice) that should be given high priority?
Mapping DSCP or CoS Values to an Ingress Queue and Setting WTD Thresholds, page 33-63
(optional)
Allocating Buffer Space Between the Ingress Queues, page 33-65
Allocating Bandwidth Between the Ingress Queues, page 33-65
Configuring the Ingress Priority Queue, page 33-66
(optional)
(optional)
(optional)
Catalyst 2975 Switch Software Configuration Guide
Configuring Standard QoS
33-63