Cisco WS-C6506 Software Manual page 350

Configuring the NetFlow Statistics on the Switch
To display a summary of the NetFlow table entries and statistics, perform this task in privileged mode:
Task
Display all the NetFlow table entries
and statistics.
This example shows how to display all the NetFlow table entries (the display is from a Supervisor
Engine 2):
Console> (enable) show mls
show mls
=======
Total packets switched = 2
Total bytes switched = 112
Total routes = 48
IP statistics flows aging time = 16 seconds
IP statistics flows fast aging time = 0 seconds, packet threshold = 0
IP Current flow mask is Full flow
Netflow Data Export version:7
Netflow Data Export disabled
Netflow Data Export port/host is not configured.
Total packets exported = 0
IPX statistics flows aging time = 16 seconds
IPX flow mask is Destination flow
IPX max hop is 15
Module 15:Physical MAC-Address 00-50-3e-a9-ab-fc
Vlan Virtual MAC-Address(es)
---- -----------------------
42 00-00-0c-07-ac-00
Console>
This example shows how to display all the NetFlow table entries (the display is from a Supervisor
Engine 720):
Console> (enable) show mls
Total packets switched = 35254
Total bytes switched = 2256256
Total routes = 120569
Total number of Netflow entries = 120000
IP statistics flows aging time = 50 seconds
Long-duration flows aging time = 320 seconds
IP statistics flows fast aging time = 0 seconds, packet threshold = 0
IP Current flow mask is Full-Vlan flow
Netflow Data Export version: 7
Netflow Data Export disabled
Netflow Data Export port/host is not configured.
Total packets exported = 0
Destination Ifindex export is enabled
Source Ifindex export is enabled
Rate limiting is turned off, packets are bridged to router
Load balancing hash is based on source and destination IP addresses and universc
Per-prefix Stats for ALL FIB entries is Enabled
Console> (enable)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
13-32
Chapter 13
Command
show mls
Configuring CEF for PFC2 and PFC3A
OL-8978-04