Vtp Version 3 Show Commands - Cisco WS-C6506 Software Manual

Chapter 10 Configuring VTP
Use the set port vtp mod/port {enable | disable} command to enable or disable all VTP interaction on
a per-port basis. This capability might be used on trunks leading to nontrusted hosts. When a port is
disabled, no VTP packets are sent on the port, and any VTP packets that are received on the port are
dropped. By default, VTP is enabled and advertisements are received and sent on all trunks.
To disable VTP on a per-port basis, perform this task in privileged mode:
Task
Step 1
Disable VTP on a per-port basis.
Step 2
Verify the change.
This example shows how to disable VTP on a per-port basis and verify the configuration:
Console> (enable) set port vtp 3/1-2 disable
VTP is disabled on ports 3/1-2.
Console> (enable) show port vtp 3
Port
--------
3/1
3/2
3/3
3/4
Console> (enable)

VTP Version 3 show Commands

Use the show vtp {conflicts | devices | domain | statistics} command to show other devices in the
domain or devices in the domain with conflicting (conflicts) configurations. Use the domain keyword
to display information that is specific to the VTP domain. Use the statistics keyword to display VTP
statistics. Switches in transparent or off mode are not part of the VTP domain and do not respond to
requests. In addition, the clients or servers that do not have a valid database do not respond to requests.
OL-8978-04
VTP Status
----------
disabled
disabled
enabled
enabled
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Command
set port vtp mod/port {enable | disable}
show port vtp
Configuring VTP Version 3
10-29