Specifying The Netflow Table Entry Aging-Time Value - Cisco WS-C6506 Software Manual

Chapter 13 Configuring CEF for PFC2 and PFC3A

Specifying the NetFlow Table Entry Aging-Time Value

The entry aging time for each protocol (IP and IPX) applies to all the protocol-specific NetFlow table
entries. Any entry that has not been used for agingtime seconds is aged out. The default is 16 seconds.
For normal aging time, you can specify the aging time in the range of 1–1092 seconds in 8-second
increments. Any aging-time value that is not a multiple of 8 seconds is adjusted to the closest multiple
of 8 seconds. For example, a value of 65 is adjusted to 64 and a value of 127 is adjusted to 128.
To specify the entry aging time for both IP and IPX, perform this task in privileged mode:
Task
Specify the aging time for the NetFlow table entries. set mls agingtime [agingtime]
This example shows how to specify the entry aging time:
Console> (enable) set mls agingtime 16
Multilayer switching agingtime IP and IPX set to 16
Console> (enable)
To specify the IP entry aging time, perform this task in privileged mode:
Task
Specify the IP entry aging time for the NetFlow
table.
This example shows how to specify the IP entry aging time:
Console> (enable) set mls agingtime ip 16
Multilayer switching aging time IP set to 16
Console> (enable)
To specify the IPX entry aging time, perform this task in privileged mode:
Task
Specify the IPX entry aging time for the NetFlow
table.
This example shows how to specify the IPX entry aging time:
Console> (enable) set mls agingtime ipx 16
Multilayer switching aging time IPX set to 16
Console> (enable)
OL-8978-04
Command
Command
set mls agingtime ip [agingtime]
Command
set mls agingtime ipx [agingtime]
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring the NetFlow Statistics on the Switch
13-29