Disabling Global Support For 802.1Q Tunneling - Cisco WS-C6506 Software Manual

Catalyst 6500 series switch

Hide thumbs Also See for WS-C6506:

Table of Contents

Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling

This example shows how to clear tunneling on port 4/1 and verify the configuration:

Console> (enable) set port dot1qtunnel 4/1 disable

Dot1q tunnel feature disabled on port 4/1.

Console> (enable) show port dot1qtunnel 4/1

Disabling Global Support for 802.1Q Tunneling

The set port dot1qtunnel all disable command is the only command that is required to clear 802.1Q

tunneling from the port. You do not need to enter the set dot1q-all-tagged disable command to clear

802.1Q tunneling.

To disable global support for 802.1Q tunneling on the switch, perform this task in privileged mode:

Disable global tunneling support on the switch.

Verify the configuration.

This example shows how to disable tunneling support on the switch and verify the configuration:

Console> (enable) set port dot1qtunnel all disable

Dot1q tunnel feature disabled on all applicable ports.

Console> (enable) show port dot1qtunnel

Dot1q tunnel mode

-----------------

Dot1q tunnel mode

-----------------

set port dot1qtunnel all disable

show port dot1qtunnel

Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7

Configuring 802.1Q Tunneling on the Switch

Show Quick Links

Table of Contents

Catalyst 6506 Catalyst 6509 Catalyst 6513