Cisco WS-C6506 Software Manual page 388

Configuring MLS
Configuring IP MMLS on the MSFC
These sections describe how to configure the MSFC for IP MMLS:
•
•
•
•
•
•
•
•
•
Note For information on configuring routing on the MSFC, see
Routing."
You can specify the MSFC as the MLS route processor (MLS-RP) for Catalyst 5000 family switches
Note
using MLS. Refer to the Layer 3 Switching Configuration Guide—Catalyst 5000 Family, 2926G Series,
2926 Series Switches for the Catalyst 5000 family switch MLS configuration procedures.
This section describes how to enable IP multicast routing on the MSFC. For more detailed IP multicast
Note
configuration information, refer to the "IP Multicast" section of the Cisco IOS IP and IP Routing
Configuration Guide at this URL:
http://www.cisco.com/en/US/docs/ios/12_1/iproute/configuration/guide/ip_c.html
Enabling IP Multicast Routing Globally
You must enable IP multicast routing globally on the MSFC before you can enable IP MMLS on the
MSFC interfaces.
To enable IP multicast routing globally on the MSFC, perform this task in global configuration mode:
Task
Enable IP multicast routing globally.
This example shows how to enable IP multicast routing globally:
Router(config)# ip multicast-routing
Router(config)#
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
14-32
Enabling IP Multicast Routing Globally, page 14-32
Enabling IP PIM on MSFC Interfaces, page 14-33
Configuring the IP MMLS Global Threshold, page 14-33
Enabling IP MMLS on MSFC Interfaces, page 14-33
Displaying IP MMLS Interface Information, page 14-34
Displaying the IP Multicast Routing Table, page 14-34
Monitoring IP MMLS on the MSFC, page 14-35
Using Debug Commands on the IP MMLS MSFC, page 14-36
Using Debug Commands on the SCP, page 14-37
Chapter 12, "Configuring InterVLAN
Command
Router(config)# ip multicast-routing
Chapter 14 Configuring MLS
OL-8978-04