Disabling Portfast - Cisco WS-C6506 Software Manual

Configuring PortFast on the Switch
This example shows how to enable PortFast on port 1 of module 4 of a trunk port, bring the trunk port
to a forwarding state, and verify the configuration (the PortFast status is shown in the "Fast-Start"
column):
Console> (enable) set spantree portfast 4/1 enable trunk
Warning:Connecting Layer 2 devices to a fast start port can cause
temporary spanning tree loops. Use with caution.
Spantree port
Console> (enable) show spantree 4/1
Port
Channel_id
------------------------ ---- ------------- --------- ---- ------------------
4/1
4/1
4/1
4/1
4/1
4/1
Console> (enable) show spantree portfast 4/1
Portfast:enable trunk
Portfast BPDU guard is disabled.
Portfast BPDU filter is disabled.
Console>
Note When PortFast is enabled between two switches, the system will verify that there are no loops in the
network before bringing the blocking trunk to a forwarding state.

Disabling PortFast

To disable PortFast on a switch or trunk port, perform this task in privileged mode:
Task
Step 1 Disable PortFast on a switch port.
Step 2 Verify the PortFast setting.
This example shows how to disable PortFast on port 1 of module 4:
Console> (enable) set spantree portfast 4/1 disable
Spantree port 4/1 fast start disabled.
Console> (enable)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
9-10
Chapter 9 Configuring Spanning-Tree PortFast, UplinkFast, BackboneFast, and Loop Guard
4/1 fast start enabled.
Vlan Port-State
1 blocking
100 forwarding
521 blocking
524 blocking
1003 not-connected
1005 not-connected
Cost Prio Portfast
4 32 enabled
4 32 enabled
4 32 enabled
4 32 enabled
4 32 enabled
4 32 enabled
Command
set spantree portfast mod_num/port_num
disable
show spantree mod_num/port_num
0
0
0
0
0
0
OL-8978-04