Adding/Removing A Line - Lucent Technologies MERLIN LEGEND Release 7.0 System Manager's Quick Reference

MERLIN LEGEND Communications System R7.0
System Manager's Quick Reference 555-670-119
Managing the System
Managing Telephones

Adding/Removing a Line

You must contact your central office to obtain a new line or to disconnect a line. If
you are adding a line, after the central office is contacted, call Lucent
Technologies at 1-800-247-7000 to arrange for a Lucent Technologies technician
to connect the line to the system and set it up (charges may apply).
NOTE:
If you are adding a line but there is no spare jack, you also need to add
a new module. Contact your Lucent Technologies representative. After
the line is connected and set up, or after it is disconnected, you must
program it.
Assign the line to or unassign the line from a pool, to/from extensions (if it is a
personal line), to/from a calling group, or to/from Remote Access, as appropriate.
See "Extensions" in Chapter 3 in System Programming .
no. Type no. of rings (1 to
9)
Change the delay for Primary Cover buttons programmed
for Delay Ring; change the additional delay before a call
is sent to Group Coverage receivers when Primary or
Secondary Coverage Receivers are available:
no. Type no. of rings (1 to
6)
Change the delay for Secondary Cover buttons
programmed for Delay Ring:
no. Type no. of rings (1 to
6)
Issue 1
April 1999
62
Type sender's ext.
Type sender's ext.
Type sender's ext.