Assigning/Unassigning Trunks Or Pools To Extensions; Assigning/Unassigning Icom Or Sa Buttons - Lucent Technologies MERLIN LEGEND Release 7.0 System Manager's Quick Reference

MERLIN LEGEND Communications System R7.0
System Manager's Quick Reference 555-670-119
Managing the System
Managing Telephones

Assigning/Unassigning Trunks or Pools to Extensions

If you are adding or removing a personal line, Loudspeaker Paging, or Pool
buttons (Hybrid/PBX only), use this procedure to assign or unassign the outside
lines/trunks to the buttons on the telephone.
Console Procedure
PC Procedure

Assigning/Unassigning ICOM or SA Buttons

Use this procedure to assign or unassign the Intercom (ICOM) buttons used to
make and receive inside calls. In Hybrid/PBX mode only, use this procedure to
assign or unassign System Access (SA) buttons used to make and receive
inside and outside calls.
Console Procedure
To program a single line/trunk:
Extensions Lines/Trunks
no.
Enter Entry Mode
no.
Enter Exit
To program a block of lines/trunks:
Extensions Lines/Trunks
no. Select trunk range
Enter
on/off
Enter Exit
Exit
To program a single line/trunk:
Type ext. no.
line/trunk no.
To program a block of lines/trunks:
Type ext. no.
range
Toggle letter G on/off
To program an extension:
Sys
More
Programming
Dial ext. no.
Ext
Dial ext.
Dial line/trunk
Exit
Dial ext.
Toggle LED
Select trunk
Cntr-Prg
Enter Start
Issue 1
April 1999
55
Type
Program
Select