Adding/Removing A Line - Lucent Technologies MERLIN LEGEND System Manager's Manual

MERLIN LEGEND Communications System Release 5.0
System Manager's Guide 555-650-118
6 Managing the System

Adding/Removing a Line

Adding/Removing a Line
Use this procedure to add a line to or remove a line from the system.
Planning Guidelines
If you are adding a new line and need to order a module to connect the line,
coordinate the installation and connection dates to ensure that the new module is
installed before the line is connected to the system.
Task List: Adding/Removing a Line
o
Obtain Form 2c, System Numbering: Line/Trunk Jacks. Check the form to
confirm that there is a spare jack.
o
Contact your central office (CO) to obtain a new line or to disconnect a line.
o
If you are adding a line/trunk, call Lucent Technologies 1 800 247-7000 to
arrange for a Lucent Technologies technician to connect the line to the
system and set it up (charges may apply). If you are removing a line, it is
not necessary to make any such arrangements.
o
After the line is connected and set up or is disconnected, open the System
Programming menu from the console or a PC with SPM to program it as
described in the next task.
o
Assign the line to or unassign the line from a pool, to/from extensions (if it
is a personal line), to/from a calling group, or to/from Remote Access, as
appropriate, following the instructions in the "Telephones" section of
Chapter 3 in System Programming .
o
Revise the appropriate planning form(s).
o
When you have finished, file the form(s) with the rest of the planning forms.
Programming Instructions
See the appropriate procedures in System Programming as noted in the task list
above.
NOTE:
If you are adding a line but there is no spare jack, you need to add a
new module. Contact your Lucent Technologies representative.
NOTE:
A new module must be installed before a line is connected to it.
6
6
6
6
Issue 1
June 1997
Page 6-56