Programming For Music-On-Hold; Programming For Loudspeaker Paging - Lucent Technologies MERLIN LEGEND Release 7.0 System Manager's Quick Reference

MERLIN LEGEND Communications System R7.0
System Manager's Quick Reference 555-670-119
Managing the System
Managing Telephones
Music-On-Hold, loudspeaker paging equipment, maintenance alarms, or a fax
machine.
This section also provides procedures to specify the extensions that receive a
message-waiting indication (MWI) and procedures to specify the touch-tone
duration and the interval between digits in codes sent between the voice
messaging system and the communications system.

Programming for Music-On-Hold

Use this procedure to identify the line/trunk jack reserved for connection of a
music source, such as a radio, tape player, or stereo system. Only one
Music-On-Hold line/trunk jack is allowed per system. Note the following
conditions:
• You cannot assign the line/trunk identified for Music-On-Hold to a line/trunk
pool. If the line/trunk is currently assigned to a pool, you must remove it
before you program this option.
• You cannot assign the line/trunk identified for use with Music-On-Hold to a
button on any telephone or as a Remote Access trunk.
• You cannot use the line/trunk jack identified for Music-On-Hold for a
loudspeaker paging system or maintenance alarm.
In Release 6.0 and later systems, each system in a private network must have its
own music source. A music source connected to a remote private networked
switch cannot be used by the local system.
Console Procedure
PC Procedure

Programming for Loudspeaker Paging

Use this procedure to identify the line/trunk jack reserved for connection of
loudspeaker paging equipment. A maximum of three single-zone or multizone
AuxEquip MusicOnHold
no. Enter
Exit
Type line/trunk no.
Issue 1
April 1999
Dial line/trunk
74