Web Interface: Create A Tunnel - NETGEAR ProSafe GSM5212P Software Administration Manual

ProSafe Managed Switch

Web Interface: Create a Tunnel

Configure Switch GSM7328S_1
1. Enable IP routing on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Enable IPv6 forwarding and unicast routing on the switch.
a. Select Routing > IPv6 > Basic> Global Configuration. A screen similar to the
following displays.
b. For IPv6 Unicast Routing, select the Enable radio button.
c. For IPv6 Forwarding, select the Enable radio button.
d. Click Apply.
3. Create a routing interface and assign an IP address to it.
Chapter 26. Tunnel | 385