NETGEAR ProSafe GSM5212P Software Administration Manual page 353

ProSafe Managed Switch
CLI: Configure a DHCP Reservation
(Netgear Switch)#config
(Netgear Switch) (Config)#service dhcp
(Netgear Switch) (Config)#ip dhcp pool pool_manual
(Netgear Switch) (Config)#client-name dhcpclient
(Netgear Switch) (Config)#hardware-address 00:01:02:03:04:05
(Netgear Switch) (Config)#host 192.168.200.1 255.255.255.0
(Netgear Switch) (Config)#client-identifier 01:00:01:02:03:04:05
Note: The unique identifier is a concatenation of the media type and MAC
addresses. For example, the Microsoft client identifier for Ethernet
address c8:19:24:88:f1:77 is 01:c8:19:24:88:f1:77, where 01
represents the Ethernet media type. For more information, see the
"Address Resolution Protocol Parameters" section of RFC 1700.
Web Interface: Configure a DHCP Reservation
1. Select System > Services > DHCP Server > DHCP Server Configuration. A screen
similar to the following displays.
2. For Admin Mode, select the Enable radio button.
3. Click Apply to enable the DHCP service.
Chapter 22. DHCP Server | 353