NETGEAR ProSafe GSM5212P Software Administration Manual page 514

are used to configure captive portal. VSAs are denoted in the ID column and are comma
delimited (vendor ID, attribute ID).
Table 3. RADIUS Attributes for Configuring Captive Portal Users
RADIUS Attribute No.
User-Name 1
User-Password 2
Session-Timeout 27
Idle-Timeout 28
WISPr-Max-Band 14122, 7
width-Up
WISPr-Max-Band 14122, 8
width-Down
CLI: Configure RADIUS as the Verification Mode
(Netgear Switch) (Config-CP 1)#radius-auth-server Default-RADIUS-Server
(Netgear Switch) (Config-CP 1)#verification radius
514 | Chapter 32. Captive Portal
Description
User name to be authorized.
User password.
Logout once session timeout is
reached (seconds). If the attribute is
0 or not present then use the value
configured for the captive portal.
Log out once idle timeout is reached
(seconds). If the attribute is 0 or not
present, then use the value
configured for the captive portal.
Maximum client transmit rate (b/s).
Limits the bandwidth at which the
client can send data into the network.
If the attribute is 0 or not present,
then use the value configured for the
captive portal.
Maximum client receive rate (b/s).
Limits the bandwidth at which the
client can receive data from the
network. If the attribute is 0 or not
present, then use the value
configured for the captive portal.
ProSafe Managed Switch
Range Usage
1–32 characters Required
8–64 characters Required
Integer Optional
(seconds)
Integer Optional
(seconds)
Integer Optional
Integer Optional
Default
None
None
0
0
0
0