Create Two Vlans - NETGEAR ProSafe GSM5212P Software Administration Manual

and ports 1/0/3 and 1/0/4 are members of VLAN 3 only. The script following the diagram shows
the commands you would use to configure the switch as shown in the diagram.
Port 1/0/2 VLAN
Router Port 1/3/1
192.150.3.1
Layer 2
Switch
VLAN 10
Figure 1. Switch with 4 ports configured for traffic from 2 VLANs
The following examples show how to create VLANs, assign ports to the VLANs, and assign a
VLAN as the default VLAN to a port.

Create Two VLANs

The example is shown as CLI commands and as a Web interface procedure.
CLI: Create Two VLANS
Use the following commands to create two VLANs and to assign the VLAN IDs while leaving
the names blank.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 2
(Netgear Switch) (Vlan)#vlan 3
(Netgear Switch) (Vlan)#exit
Web Interface: Create Two VLANS
1. Create VLAN2.
10 | Chapter 2. VLANs
Layer 3 switch
Port 1/0/3 VLAN
Router Port 1/3/2
192.150.4.1
Port 1/0/1
Layer 2
Switch
VLAN 20
ProSafe Managed Switch