NETGEAR ProSafe GSM5212P Software Administration Manual page 466

3. Create a routing interface connecting to the client.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#interface 1/0/16
(Netgear Switch) (Interface 1/0/16)#routing
(Netgear Switch) (Interface 1/0/16)#ip address 10.200.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/16)#exit
4. Configure the DHCP Server IP address and enable the DHCP L3 relay.
(Netgear Switch) (Config)#ip helper-address 10.100.1.1 dhcp
(Netgear Switch) (Config)#ip helper enable
5. Redistribute 10.200.1.0/24 and 10.200.2.0/24 to the RIP such that RIP adviertises this route
to the DHCP server.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config-router)#redistribute connected
(Netgear Switch) (Config-router)#exit
Web Interface: Configure a DHCP L3 Relay
1. Enable routing mode on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Create a routing interface and assign 10.100.1.2/24 to it.
466 | Chapter 29. DHCP L2 Relay and L3 Relay
ProSafe Managed Switch